Loading ...
Loading ...
Loading ...
To adjust oven thermostat:
Use time given on recipe when
cooking for first time. Oven
thermostats may “drift” from the
factory setting over the years, and
5 to 10-minute differences in timing
between an old and a new oven are
not unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brown too little or too much, you
may make a simple adjustment in
the OVEN TEMP thermostat knob.
PULL KNOB OFF SHAFT. LOOK
AT BACK OF KNOB AND NOTE
CURRENT SETTING BEFORE
MAKING ANY ADJUSTMENT.
To increase temperature, turn
toward HI or RAISE; to decrease,
turn toward LO or LOWER. Each
notch changes temperature 10”F.
Note: Although the back of the
Oven
12mp
knob on your range may
differ
in
appearance
horn
those shown
ie>e,
it can be
dju;ted
by following
the appropriate instructions below
and at right.
To adjust oven thermostat:
1.
Pull off knob. Loosen both
screws on back of knob.
2. Move pointer one notch in
desired direction. Tighten screws.
3.
Return knob to oven, matching
flat area of knob to shaft. Recheck
oven performance before making
an additional adjustment.
1.
Remove knob, and hold so
pointer is at top of knob. Using a
To clean in self-cleaning oven:
Place shelf from upper oven on a
shelf of the self-clean oven. (The
shelf may have to be shifted slightly
so shelf stops do not interfere with
placement of panels. )
Slide out oven bottom; lifting bake
unit slightly makes this easier to do.
Lift back panel and remove. Place
pot holder or similar material, hold
bottom and back
~anels
back-to-
“skirt” of knob firmly in one hand.
Grasp handle of knob in other
hand. Note position of pointer and
turn handle to move pointer toward
Raise or Lower. Pointer is designed
not to move easily. If it is seated so
it is difficult to move, pointer may
be loosened slightly. Insert a thin
screwdriver, knife blade or similar
instrument and lift up end of
pointer slightly.
2. After adjustment is made, press
pointer firmly against knob. Return
knob to range, matching flat area
on knob and shaft.
Recheck oven performance before
making an additional adjustment.
back so soiled
sides
face outward.
It is important that panels lay flat
on shelf.
Lift side panels up and out of oven.
Place back-to-back on remaining
self-clean shelf.
To replace panels
in self-cleaning oven:
Replace panels in any order desired.
Be certain oven bottom is replaced
so notch is at right, and “feet” on
bake unit rest in depressions in
panel. Replace broiler reflector so
“open side” is toward bottom of oven.
31
—
Loading ...
Loading ...
Loading ...