Loading ...
Loading ...
Loading ...
32 CP4 STAGE/CP40 STAGE Owner’s Manual
Quick Start Guide
5 Move the cursor (R) to Preset using the [r]
button, and select a preset* for the effect type
from Step 4 using the Data Dial. (*: Each
preset configures all parameters to suit a
specific need.)
NOTE While each preset configures all parameters to suit a
specific need, you can adjust these parameters if
necessary. To do so, press the [d] button to move to the
screen’s other panes.
6 When you have finished setting the chorus
effect, press the [EXIT] button.
The Common Edit menu will again be displayed.
7 Use the [d] button to select 02: Reverb Effect,
and then press the [ENTER] button.
The Reverb Effect screen will be displayed.
8 Use the Data Dial to change the reverb effect
type.
9 Use the [d] button to move to the screen’s
next pane and edit the parameters for the
effect type from Step 8 using the [l] and [r]
buttons and the Data Dial.
10 Using the [SLIDER FUNCTION] button and
the Part sliders, adjust the chorus send
level (CHORUS) and the reverb send level
(REVERB). (Refer to Part sliders (page 28)
for details on how to do so.)
The degree to which chorus and reverb are applied
to the affected Parts will change.
Setting insertion effects
Insertion effect settings can be configured for each of a
Performance’s Parts. Two are available for use in a
Performance, each containing two independent effects,
A and B. As an example of setting parameters in the
Performance Part Edit area, the following procedure
describes how to configure these effects for one of the
current Performance’s Parts.
1 Ensure that the Part for which you wish to
configure insertion effects is turned on (i.e.,
its Part button is lit).
If necessary, turn on the Part by pressing its Part
button.
2 Select the Part by pressing its Part button
with the [PART SELECT] button held down.
NOTE
• You can also select the Part to edit after displaying the Edit
menu in the following step.
• On the CP40 STAGE, pressing either the [LAYER] or [SPLIT]
button essentially selects the same Part.
Common Ctg T
ChorusEff CHO SPX
ype Preset E
Cho R SlowD
Effect preset
EDIT Common
D01:Chorus Effect
E
Common
ReverbEff
Type E
RWoodRoomD
Effect type
Common
ReverbEff
RevTime HPF E
R2.0s 20HzU
Effect parameter
Tip
Edit symbol for Performances
Whenever you edit any of a Performance’s
parameters, the
E (Edit) symbol will be displayed at
the top-right of the screen. The purpose of this symbol
is to remind you that edits have been made but not yet
stored. All edits made to the current Performance can
be stored using the Store Performance function
(page 34). Once stored, the Edit symbol will
disappear.
Common Ctg T
ChorusEff CHORG
ype Preset E
Cho BasicD
Hold
Loading ...
Loading ...
Loading ...