Loading ...
Loading ...
Loading ...
19
En
Preparation
05
Attaching the stand
1 With the plasma display lying flat, fit the stand’s
support columns to the bottom of the plasma display as
indicated by the arrows, then slowly insert them.
• Be extremely careful not to insert the support columns of
the stand into any part of the plasma display other than the
stand insertion slots. Doing so might damage the plasma
display panel or its ports or result in warping of the stand.
2 Attach the stand at the points indicated by the arrows
and tighten the installation bolts (2) and (1) firmly using
a screwdriver.
Installation bolts (1): M8 x 23 mm (black) for PRO-110FD
M6 x 20 mm (black) for PRO-150FD
Installation bolts (2): M8 x 40 mm (black) for PRO-110FD
M6 x 20 mm (black) for PRO-150FD
3 Replace the plasma display to stand upright.
For speaker installation, see Installing the Pioneer
speaker.
Note
• Be sure to install the plasma display in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
• If the speaker has been installed, it is recommended to detach
the speaker before attaching the stand.
Installing the Pioneer speaker
Caution
• Do not move the display holding on to the mounting fittings.
This can result in injury or damage to the unit.
About the speaker
• In order to prevent damage to the speaker system resulting
from input overload, please observe the following precautions:
• Do not use the speaker with anything other than the plasma
display. Doing so may result in damage or fire.
• Be sure to turn the connected devices off and remove the
power cord from the power outlet beforehand when changing
the connection or installation method.
• When using a tone control function to greatly emphasize treble
sounds, do not use excessive amplifier volume.
• Please handle the speaker with sufficient care, as the grille net
and the cabinet can become damaged or broken when they are
subjected to strong external impacts.
• Placing a CRT computer screen or CRT monitor near to the
speaker may result in interference or color distortion. If this
happens, distance the monitor from the speaker.
Installation
• When installing the speaker, do not use any screws other than
those supplied, otherwise the speaker may come off from the
main unit and fall over.
• When installing the speaker, tighten the screws firmly.
• Steps for attaching the stand are the same for PRO-150FD
and PRO-110FD (use the screw holes with “T” inscribed).
Sheet
Plasma
display
Insert the stand into the
plasma display so that an
arrow with “FRONT/FACE
AVANT” mark inscribed at
the bottom of the stand
indicates downward.
(PRO-150FD)
Installation bolts (1)
(Step 2)
Installation bolts (2)
(Step 1)
(PRO-150FD)
PRO150FD.book Page 19 Tuesday, June 12, 2007 12:37 PM
Loading ...
Loading ...
Loading ...