Loading ...
Loading ...
Loading ...
18
En
Preparation
05
Attaching the light-blocking shield (PRO-150FD only)
This part prevents reflection of the cables connected to the back
of the plasma display on the base cover.
Note
• Attach it after anchoring the base cover on a flat stable place.
1 Remove the double-sided adhesive tape from
the light-blocking shield.
2 While firmly holding the ends of the light-
blocking shield, apply it with the double-
sided adhesive tape.
Note
• Be careful that the light-blocking shield does not catch on the
pipe insertion holes.
• Anchor it in place so that there are no gaps (See diagram at
below). If there is a gap, the light-blocking shield may peel off.
3 Anchor it in place while pressing it down
from above.
Light-blocking shield
Front
Rear
Base cover
Remove each double-sided
adhesive tape.
Rear
Front
Front
Rear
Press
Be sure that
there is no gap.
Press
PRO150FD.book Page 18 Tuesday, June 12, 2007 12:37 PM
Loading ...
Loading ...
Loading ...