Loading ...
Loading ...
Loading ...
Parameter Description
PIR Alarm
PIR function helps enhancing the accuracy and validity of motion
detect. It can lter the meaningless alarms that are activated by the
objects such as falling leaves, ies. The detection range by PIR is
smaller than the eld angle.
PIR function is enabled by default if it is supported by the cameras.
Enabling PIR function will get the motion detect to be enabled
automatically to generate motion detection alarms; if the PIR function
is not enabled, the motion detect just has the general eect.
●
Only when the channel type is CVI, the PIR function can be enabled.
●
If the camera does not support PIR function, it will be unusable.
●
If the Device does not support PIR function, it will not be displayed
on the page.
Schedule Dene a period during which the motion detection is active.
Anti-Dither
Congure the time period from end of event detection to the stop of
alarm.
Alarm-out Port
Click Setting to congure the parameters.
●
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
●
External Alarm: Enable alarm activation through the connected
alarm box.
●
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning o alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will
be no delay.
Show Message
Select the Show Message checkbox to enable a pop-up message in
your local host PC.
Report Alarm
Select the Report Alarm checkbox, and then click Setting next to
Report Alarm to select Private Protocol or HTTP in the Protocol
Type.
You can enable the system to upload the alarm signal to the network
(including alarm center) when an alarm event occurs.
Send Email
Select the Send Email checkbox to enable the system to send an
email notication when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
User's Manual
182
Loading ...
Loading ...
Loading ...