Loading ...
Loading ...
Loading ...
7. Main Menu ELP-301016
7.1 Main Menu Modes
20
X Mode
Pressing the MODE key once will take you to the X mode. The X mode is used to
perform Sales Reports using information obtained during normal daily operations of the
scale. Several types of reports are available in the X mode. There are both daily and
monthly reports available. Some report categories available are By PLU, By Department
and By Group. Some other special functions available are Exporting Sales Data and
printing a PLU List. For a detailed explanation of these functions please refer to the
appropriate section(s) of this manual.
S Mode
Pressing the MODE key twice will take you to the S mode. The S mode is where most of
the programmed information used during daily operations is directly entered at the
scale. (The same information may also be entered using the XDB Manager Software
program where available.) There are several programming items available, from
selecting which information fields are visible when programming a commodity or PLU to
programming date and time controlled discount sales. Each of the many functions is
explained in the S mode (Programming Mode) section of this manual.
Z Mode
Pressing the MODE key three times will take you to the Z mode. The Z mode is mainly
used to reset information in the scale back to a factory default configuration or clearing
the programmed information out of memory. Most types of programmed information
may be conveniently reset or cleared individually. Stored Sales Information can also be
reset/cleared using the Z mode. There are several other special functions available in
the Z mode such as compressing and recreating the commodity database, printing the
system activity log, printing the firmware upgrade information, printing the scale
calibration record and backing up and restoring programmed information.
P Mode
If the P mode has been enabled in the SPEC program, pressing the MODE key four times
will take you to the P mode. The P mode is used to provide some level of security when
accessing or programming information in the scale. It is not normally visible in the Main
Menu list and must be enabled using the SPEC configuration mode. When enabled and
configured correctly a password will be required to access the X, S and Z modes in the
scale.
Loading ...
Loading ...
Loading ...