Loading ...
Loading ...
Loading ...
18
If there is dirt or debris accumulated in the handheld shampoo nozzle, press the release button and
remove the cover from the nozzle for cleaning (Fig. 15).
10. Plug the power cord into a power outlet (Fig. 16).
11. Turn on the motor by ipping the switch to the “I” ON position and the machine is ready for use.
Press the detergent mode button, indicated by the following symbol , on either the remote-
control handle or the powerhead for cleaning solution application only. Select both the detergent
mode and vacuum mode for simultaneous shampoo and wet vacuum operation (Fig. 17).
12. Once you have completed cleaning, switch off the vacuum by pressing detergent mode button on
either the remote-control handle or the powerhead. Flip the switch to the “O” OFF position, unplug
the power cord from the power outlet and drain the liquid (Fig. 18).
O = OFF I = ON = DETERGENT MODE
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
DO NOT USE THE DUST BAG FOR LIQUID VACUUMING.
NOTE: VACUUM THE CARPET/UPHOLSTERY THOROUGHLY BEFORE USING THE SHAMPOO
MODE.
• For carpet cleaning it is recommended to remove all furniture from the room to be cleaned or move
it away from the cleaning area. Clean the whole carpet systematically in squares, using strokes of
approximately 5ft. (1.5m) each. This avoids walking over the cleaned carpet until it is completely dry.
• Start furthest away from the entrance of the room, extend the hose, and work backwards.
• Pull the carpet shampoo nozzle back towards you in approximately 5ft. strokes. Rell the cleaning
solution tank if the solution runs out.
•
Select the vacuum mode, indicated by the following symbol , to suck up the dirty solution. More
cleaning solution can be applied to heavily soiled areas. The dirty liquid is visible as it is sucked up
through the carpet shampoo nozzle. Stop vacuuming when the liquid being extracted is no longer dirty.
• Do not walk over or place furniture on the cleaned area until it is completely dry.
• The handheld shampoo nozzle is ideal for cleaning sofas, chairs, stairs and car interiors.
• The carpet shampoo nozzle is ideal for cleaning carpets.
DISASSEMBLING THE WET/DRY SHAMPOO VAC
NOTE: SOME LIQUID MAY REMAIN IN THE TUBES AFTER USING THE PRODUCT FOR LIQUID
OR SHAMPOO CLEANING. DISASSEMBLE THE VACUUM OUTDOORS OR OVER A SINK AS
THERE MAY BE SOME LEAKAGE.
To disassemble the shampoo vacuum, follow the steps below.
1. Remove the cleaning solution tube from the powerhead by pressing down on the orange latch.
Disconnect the hose from the vacuum.
2. Disconnect the accessories and/or extension wand from the remote-control handle by pressing
down on the release button (Fig. 19).
WARNING:
THE MOTOR NOISE CHANGES TO A HIGHER PITCH WHEN THE
COLLECTION TANK IS FULL OR BLOCKED. STOP THE VACUUM IMMEDIATELY AND
EMPTY THE COLLECTION TANK.
Loading ...
Loading ...
Loading ...