Loading ...
Loading ...
Loading ...
12
8. Your vacuum comes ready for dry vacuum cleaning. If the cartridge lter is not installed, refer to
page 20 for installation instructions (Fig. 7 & 8).
9. Optional: For improved dust ltration, t the dust collection bag ange onto the inlet port, taking
care not to damage the bag (Fig. 9).
NOTE: The dust collection bag is for dry pick-up only.
10. For wet vacuum cleaning, remove the cartridge lter, and install the supplied foam wet lter. See
page 21 for the foam wet lter installation instructions (Fig. 10).
11. Position the hose storage rack as illustrated. Squeeze the open sides of the hose storage rack
inward. Insert the hose storage rack into the channel on the front side of the powerhead just
above the top edge of the tank. Verify that the rack is secured in place as shown in (Fig. 11 & 12).
Then squeeze in the other hose storage rack and insert it into the corresponding channel making
sure it is secured.
12. Place the powerhead back on the collection tank aligning the top section with the latches, and
snap into place (Fig. 13).
13. Ensure the end of the cleaning solution tube is securely tted into the cleaning solution tank
(Fig. 14).
14. A cleaning solution delivery tube runs along the hose with a threaded connector at the end. Insert
the locking end of the hose into the vacuum port of the collection tank and turn clockwise to lock
into place. Connect the threaded connector on the end of the delivery tube onto the cleaning
solution outlet coupling on the front of the powerhead (Fig. 15).
15. Choose the desired accessory and/or the extension wand and connect it onto the remote-control
handle (Fig. 16). The air ow regulation (
①
) on the remote-control handle allows you to manually
change the amount of vacuum suction (Fig. 17).
NOTE: If the suction power is too high when cleaning, adjust the air ow regulation to decrease the
suction power (Fig. 17).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact a qualied electrician to install the proper outlet. Do not
change the plug in any way. Double insulation eliminates the need for the three-wire grounded
power cord and grounded power supply system.
PROGRAMMING THE REMOTE-CONTROL HANDLE
NOTE: The programming of the remote-control handle has been preset and is ready to be used in
both vacuum and detergent mode. Reset the remote-control handle using the steps below if unable to
operate in vacuum mode.
1. Ensure the vacuum is plugged into the power outlet.
2. Switch the on/off switch to the “I” ON position.
3. Locate the detergent mode button on the powerhead indicated by the following symbol .
4.
Press and hold the detergent mode button until the indicator light illuminates continuously (Fig. 18).
5. While the light is on, press and hold the detergent mode button on the remote-control handle until
the indicator light on the powerhead starts to ash. The remote-control handle is now programmed
to vacuum, and you should be able to operate in both detergent and vacuum modes (Fig. 19).
6. If the indicator light does not ash, repeat steps 1 to 5.
Loading ...
Loading ...
Loading ...