Loading ...
Loading ...
Loading ...
Page 36 of 64
1.
Remove the grates and check the burners, shutters, orifices, and valves for
obstructions.
2.
Spiders and insects often nest in these areas of the grill and can disrupt air flow,
causing damage to the grill and personal injury.
3.
Clean and inspect the gas hose. If there is evidence of abrasion, wear, cuts or leaks,
do not use the grill. The hose must be replaced prior to using the unit. Replace the
hose assembly with the exact type specified by Crown Verity.
Lighting Your Grill or Side Burner
Before lighting your grill or side burner, be sure you have followed the instructions in
this manual regarding proper setup, placement, gas connections leak testing and safe
operation, all of which precede this page.
STANDARD LIGHTING PROCEDURE - GRILL
•
Open roll dome so gas will not build up within the unit before lighting.
•
Make sure the main burner valves are in the OFF position (See “Figure 14”).
•
Turn the main gas supply on and wait 15 seconds.
•
Turn the pilot valve into the on position. Press down and hold the piezo ignition button (See
“Figure 14”) to engage the electronic ignition and light the pilot tube. Confirm that the pilot
is lit by looking down through the cooking grates. You will be able to feel heat coming up to
the cooking surface also. (Do Not touch the cooking grate while feeling for heat as the
surface could cause burns)
WARNING: BEFORE LIGHTING YOUR GRILL OR SIDE BURNER
•
Do not use the grill if the odor of gas is present at any time. Follow leak testing
procedures before using the unit.
• Always keep the lid open when lighting your grill.
• Releasing fuel into a closed grill before lighting will increase the risk of explosion,
property damage, personal injury or death.
• Keep your face and body as far from the grill as possible when lighting. Any time a
burner doesn’t light within 5 seconds, turn off the control, wait 5 minutes for gas to
dissipate, and repeat the lighting procedure.
• NEVER LEAVE THE GRILL UNATTENDED WHILE THE GRILL IS LIT.
Loading ...
Loading ...
Loading ...