Loading ...
Loading ...
Loading ...
Page 25 of 64
IMPORTANT:
Always close the gas supply shutoff valve before disconnecting the appliance’s
gas supply hose.
IMPORTANT:
An installer-supplied safety shutoff valve MUST be installed on the natural gas
supply line for the grill/side burner. The valve should be easily accessed and located between 3
and 20 feet (1 to 6 m) away from the appliance (always check with local codes for specified
clearances and distances). All gas connections should be made by a licensed technician. The
installation and all installer-supplied parts must conform to local codes. In the absence of local
codes, the installation and all parts should conform to the National Fuel Gas Code, ANSI Z223.1/
NFPA 54 or Natural Gas and Propane Installation Code, CSA B149.1.
IMPORTANT:
Diameter and length of the gas supply pipe may limit the pressure and BTU
delivery of gas to the oven. The installer must ensure proper delivery to the appliance or it will
not operate properly (See “Appendix B” for further details). The appliance and its individual
shutoff valve must be disconnected from the gas supply piping system during any pressure
testing of that system at pressures in excess of 1/2 psi (3.5 kPa). During any pressure testing of
the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa), the
appliance must be isolated from the system by closing its individual manual shutoff valve.
IMPORTANT:
Never run flex hose behind the firebox, run the hose at an angle, straight down,
or out of the back.
All pipe sealants must be of an approved type
.
BULK SUPPLY LIQUID PROPANE GAS REQUIREMENTS
Verify the type of gas your grill/side burner has been configured for by the factory by checking
the rating plate on the unit (See “Appendix A” for further details). Grills and side burners
configured for liquid propane (LP) gas are orificed differently than units configured for natural
gas (NG). For appliances configured for use with bulk LP tanks, a regulator is not supplied. To
purchase these options, please contact Crown Verity at 1-888-505-7240.
For Mobile Grills, the gas connection is positioned on the outside of the grill body on
the right hand back rear corner. The grills are equipped with a with a 10 foot (3 m)
hose and quick-connect fitting. The regulation of gas from the bulk tank must be
adjusted to 10.0 inches W.C. for Commercial Grills and 9.0 inches W.C. for Residential
applications. Refer to the appliances rating plates in appendix “A” (See “Figure 7” for
installation details).
Loading ...
Loading ...
Loading ...