Loading ...
Loading ...
Loading ...
Page 21 of 64
To connect the LP regulator hose assembly to the LP tank, first make sure the main
valve on the tank is completely closed. Make sure also that the control valves on the
grill are OFF. Thread the regulator inlet over the tank valve. Use care to ensure proper
alignment of the threaded coupler and avoid cross-threading or damaging the coupler.
Turn the coupler clockwise until tightened up, but do not over-tighten.
After connecting a fresh LP tank, you may need to purge air from the system. Before
lighting, open the main valve on the tank. Turn one of the burner control valves on the
grill/side burner to the HIGH position for about 15 seconds to purge air from the
system. Turn the control valve on the grill OFF and wait 5 minutes for any gas to clear.
Finally, continue with the normal lighting procedure.
FIGURE 4. LP TANK RETENTION ON MOBILE GRILLS WITH THE CCB
OPTION. NOTE: 30 LBS. TANK SHOWN CAN ONLY BE USED WITH GRILLS
THAT HAVE A BTU CAPACITY EQUAL TO OR GREATER THAN 80,000 BTU’s.
Loading ...
Loading ...
Loading ...