Loading ...
Loading ...
Loading ...
52
4. View the heat map data (click Statistics→Heat Map). Set the start time and the end time.
Click “Count” to view the heat map as shown below. The default heat map is people flow
data display. Click “Motor Vehicle” or “Non-motor Vehicle” to view the corresponding
data.
4.4.11 Video Metadata
Video Metadata: Human, motor vehicle and non-motor vehicle in the video can be classified,
counted and captured, and the relevant features can be extracted and displayed on the live
interface.
Go to Config→Event→Video Metadata interface. The setting steps are as follows:
1. Enable video metadata and select the snapshot type and the detection target.
Save Original Picture to SD Card: If it is enabled, the detected original pictures will be
captured and saved to the SD card when the targets enter the pre-defined areas.
Save Target Picture to SD Card: If it is enabled, the detected target cutout pictures will be
captured and saved to the SD card when the targets enter the pre-defined areas.
Loading ...
Loading ...
Loading ...