Loading ...
Loading ...
Loading ...
36
Save Target Picture to SD Card: If it is enabled, the detected target cutout pictures will be
captured and saved to the SD card when the targets cross the alarm line.
Note: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage”
in the local config interface first. To save snapshots to the SD card, please install an SD
card first.
Detection Target:
⚫ Human: Select it and then alarms will be triggered if someone crosses the pre-defined
alarm lines.
⚫ Motor Vehicle: Select it and then alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) crosses the pre-defined alarm lines.
⚫ Motorcycle/Bicycle: Select it and then alarms will be triggered if a vehicle with two
wheels (eg. a motorcycle or bicycle) crosses the pre-defined alarm lines.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object / target is selected, alarms will not be triggered even if line
crossing detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer
to 4.4.1 Motion Detection for details.
4. Click “Save” button to save the settings.
5. Set area and sensitivity of the line crossing alarm. Click the “Area and Sensitivity” tab to
go to the interface as shown below.
Set the alarm line number and direction. Up to 4 lines can be added. Multiple lines cannot be
added simultaneously.
Direction：A<->B, A->B and A<-B optional. This indicates the direction of the intruder/vehicle
crosses over the alarm line.
⚫ A<->B: The alarm will be triggered when the intruder/vehicle crosses over the alarm line
from B to A or from A to B.
⚫ A->B: The alarm will be triggered when the intruder/vehicle crosses over the alarm line
from A to B.
Loading ...
Loading ...
Loading ...