Briggs & Stratton 040740 PowerProtect DX 13kW Home Standby Generator

Installation and Operation Manual - Page 27

For 040740.

PDF File Manual, 124 pages, Read Online | Download pdf file

040740 photo
Loading ...
Loading ...
Loading ...
Maintenance Schedule
Obey the hourly or calendar intervals of operation, whichever
occurs first.
Every 8 Hours of Operation or Daily
Clean Debris
Check the Engine Oil Level
Every 100 Hours of Operation or Annually
Change the Air Filter
Change the Engine Oil and Filter
Replace the Spark Plugs
Check the Valve Clearance
Check the Circuit Breaker Torques
Annually
Clean the Oil Cooler Fins
Regular maintenance improves the performance and extends
the life of the generator. See an authorized dealer for service.
Generator Maintenance
The generator’s warranty does not cover items that have
been subjected to operator abuse or negligence. To receive
full value from the warranty, the operator must maintain the
generator as instructed in this manual.
The generator requires the owner to make some adjustments
periodically to correctly maintain it.
Do all of the service and adjustments at least once each
season. Obey the requirements in the Maintenance Schedule
section.
Keep the unit clean. Operate the unit in an environment that
is free of excessive dust, dirt, moisture, or any corrosive
vapors. Do not allow the cooling air inlets and outlets on the
enclosure to become clogged with snow, leaves, or other
foreign material. To prevent generator damage caused by
overheating, keep the enclosure cooling inlets and outlets
clean and unobstructed at all times.
Examine the cleanliness of the unit frequently and clean it
when dust, dirt, oil, moisture, or other foreign substances
appear on its exterior and interior surface. Inspect the air inlet
and outlet openings inside and outside the enclosure tomake
sure that no blockages are in the airflow.
NOTICE: Incorrect treatment of generator can damage it and
shorten its life.
DO NOT expose generator to excessive moisture, dust,
dirt, or corrosive vapors.
DO NOT insert any objects through cooling slots.
Clean the Generator
WARNING
Exhaust heat/gases could ignite combustibles causing a fire,
resulting in death or serious injury.
Keep the area near the generator clean and free of
debris.
NOTICE: DO NOT use direct spray from a garden hose to
clean the generator. Water can enter the engine and the
generator and cause damage.
NOTICE: Periodically inspect the engine exterior for
contamination and potential damage from dirt, leaves,
rodents, spider webs, insects, etc. and remove.
1. Before you clean your generator, you MUST do steps 1–
6 in the Servicing the System section andthen continue
to step 2 in this section.
2. Clean the generatorusing the steps that follow:
a. Wipe the exterior surfaces clean with a damp cloth.
b. Use a soft bristle brush and vacuum cleaner to
loosen and pick up dirt and debris. Use low-pressure
air (not to exceed 25 psi or 175 kPa) to blow away
dirt and debris.
c. Clear any snow, leaves, or debris from the air inlets
and outlets. Keep these openings unobstructed to
prevent generator damage caused by overheating.
3. After you clean your generator, you MUSTdo steps 8–
15 in the Servicing the System section.
Engine Maintenance
Engine Oil
Use only Briggs & Stratton
®
SAE 5W-30 full synthetic
engine oil. Other full synthetic high-quality detergent oils are
acceptable if classified for service SJ or higher.
Check Engine Oil Level
NOTICEThe dipstick or the markings on the dipstick (Figure
23)can look different than the one with your model of
generator.
Maintain the oil level between the “ADD” and the “FULL”
marks on the dipstick. Before you check the oil level, follow
these steps to make sure that an accurate reading appears
on the dipstick:
Oil must be maintained between the “ADD” and the “FULL”
marks on the dipstick. To make sure that an accurate reading
is shown on the dipstick, make sure the following steps are
taken before you check the oil level.
1. Before you do engine maintenance on your generator,
you MUST do steps 1–6 in the Servicing the System
section andthen continue to step 2 in this section.
2. If the generator was recently operating, wait five minutes
for the oil to drain back into the oil pan.
27
Not for
Reproduction
Loading ...
Loading ...
Loading ...