Loading ...
Loading ...
Loading ...
18
Ground the Generator
Unless mandated by local code, additional chassis grounding
to earth at the generator is not required. Any grounding at
the generator must use paint-piercing lock washers (or their
equivalent). Any listed terminals must be installed per the
terminal supplier’s instructions. All grounding and terminal
installations must comply with national electrical codes and
local requirements.
Engine Oil
NOTICE: Any attempt to crank or start the engine before it
has been correctly filled with the recommended oil will result
in equipment failure and service codes.
• Refer to Maintenance in the Operation section of this
manual for oil fill information.
• Damage to equipment resulting from failure to obey this
instruction will void the engine and generator warranty.
This engine ships from the factory pre-run and filled with
full synthetic oil (API SJ/CF 5W-30). This allows for system
operation in a wide range of temperature and climate
conditions. Before starting the engine, check the oil level as
described in the Maintenance section of this manual.
The use of full synthetic oil does not alter the required oil
change intervals described in the Operation section of this
manual.
Battery
WARNING
Storage batteries give off explosive hydrogen gas during
recharging. Slightest spark could ignite hydrogen and cause
explosion, resulting in death or serious injury.
• DO NOT dispose of battery in a fire. Recycle battery.
• DO NOT allow any open flame, spark, heat, or lit
cigarette during and for several minutes after charging a
battery.
• Discharge static electricity from body before touching
batteries by first touching a grounded metal surface.
WARNING
Battery electrolyte fluid contains acid and is extremely
caustic. Contact with battery contents could cause severe
chemical burns.
• DO NOT open or mutilate the battery.
• Wear protective goggles, rubber apron, rubber boots
and rubber gloves.
• Immediately wash electrolyte from skin with water.
• If electrolyte contacts eyes, immediately flush with water
and seek medical attention.
• Spilled electrolyte is to be washed down with an acid
neutralizing agent.
• A common practice is to use a solution of one pound
(500 grams) bicarbonate of soda to one gallon (4 liters)
of water. The bicarbonate of soda solution is to be
added until the evidence of reaction (foaming) has
ceased. The resulting liquid is to be flushed with water
and the area dried.
The installer must supply and install a rechargeable 12 V
starting battery. The starting battery MUST conform to the
specifications shown in the chart that follows.
Battery Specifications
Specifications Standard Cold Start (Less
than 30 °F / -1 °C)
Volts 12 VDC 12 VDC
Amps (Minimum) 540 CCA (Cold
Cranking Amps)
800 CCA(Cold
Cranking Amps)
Construction Wet Lead Acid Wet Lead Acid
Terminal Type Top Post Type Battery Top Post Type Battery
Dimensions (Maximum) BCI Size 26 or BCI Size
51
BCI Size 24
21
Not for
Reproduction
Loading ...
Loading ...
Loading ...