Loading ...
Loading ...
Loading ...
Page 41
SHUTTING DOWN THE SYSTEM
NOTICE
Turning o the water supply to your pump with the engine running will damage the pump.
Damage caused by running the pump without water is not covered under warranty. To
avoid this hazard always turn o the engine before shutting o the water supply.
PUMP DAMAGE
NOTICE
Using chemical cleaners and/or corrosive liquids can damage the pressure washer seals
and internal components. Damage caused by chemical cleaners and corrosive liquids
is not covered under warranty. To avoid these hazard, only used approved cleaning
chemicals, never use bleach, and always run clean water through the pressure washer
after using cleaning chemicals.
CHEMICAL CLEANERS
1. Turn the burner control switch to OFF.
2. Squeeze the trigger and allow the water to ow until the spray wand becomes cool
to the touch, minimum of two minutes.
3. If you used soap or detergent, place the siphon hose into a bucket of clean water.
With the black nozzle attached to the wand, squeeze the trigger and allow water to
ow until all signs of soap are gone.
5. If your unit is electric powered, turn the pump ON/OFF switch to OFF.
6. For a gasoline or diesel engine, move the throttle to slow (if equipped). Turn the key
or engine switch to OFF.
7. Turn the fuel valve to OFF or CLOSED (if equipped).
8. Turn the water source o.
9. Squeeze the trigger to release any stored pressure from the hose.
10. Disconnect the garden from both the source hose bibb and the pump inlet.
11. Disconnect the high-pressure hose from the pressure washer outlet. Drain the
hose then carefully coil.
12. Refer to the STORAGE section for proper short or long-term storage instructions.
4. Set the trigger lock.
Loading ...
Loading ...
Loading ...