Loading ...
Loading ...
Loading ...
4. Thread the high-pressure hose into the gun.
Page 19
Before connecting a water supply hose, be sure the water supply is capable of providing an
uninterrupted source of clean, cold water at a minimum rate of 5 gallons per minute (GPM)
and 20 pounds per square inch (PSI) of pressure. Once a proper water supply is secured,
follow the instructions below to connect both the water supply and high-pressure hoses to
the pressure washer.
CONNECTING HOSES
Verify the inlet screen is free of any dirt or debris and is in
place with the convex side facing out.
1.
Turn on the water supply and run for 30 seconds to purge
any debris from the supply hose. Then, turn o the water
supply and thread the water supply hose into the pump
inlet.
2.
While pulling back on the pump outlet collar, insert the hose connector then release
the collar. Gently tug on the hose to make sure it is locked.
3.
ADDING THE PUMP BREATHER CAP (if applicable)
The RED shipping plug, on the top of the pump, must be replaced with a BLACK breather
cap. The cap is easy to replace with the following steps:
RED shipping plug
BLACK breather cap
1. Using a bladed screw driver, remove the RED shipping plug from the top of the pump.
2. Hand thread the BLACK breather cap into the pump.
3. Snug the cap with your ngers.
Loading ...
Loading ...
Loading ...