Loading ...
Loading ...
Loading ...
Page 36
STARTING THE ENGINE
WARNING:WARNING:
Attempting to start the engine incorrectly or using the pressure washer incorrectly can
result in engine and/or pressure washer damage, and may cause serious injury or death.
To avoid these hazards, be sure to read, understand, and follow the steps outlined in the
OPERATING CHECKLIST section of the owner’s manual before starting the engine, and
follow all the guidelines for proper use of the pressure washer.
OPERATING CHECKLIST
NOTICE
Running the pressure washer for more than two minutes without the spray gun trigger
pulled will overheat the pump and possibly cause damage. The thermal relief valve will
open and spray water to help cool the pump as it overheats. To avoid overheating the
pump, shut o the machine if not being used for longer than two minutes.
PUMP DAMAGE
Starting the Engine (Gasoline engine - Electric start)
1. Completely read and understand the Engine Owner’s Manual you received along
with this manual.
2. Complete the steps in the OPERATING CHECKLIST, CONNECTING HOSES and
PURGING AIR FROM THE PUMP sections of this manual before starting the engine.
3. For a COLD engine, set the choke to “CHOKE” -or- “CLOSED”.
4. Set the throttle to “FAST” (if equipped).
5. Turn the fuel valve to “ON” -or- “OPEN” (if equipped).
6. Turn the key past “ON” to “START” and hold for no longer than ve seconds. If the
engine does not start within ve seconds, release the key and wait one minute before
trying again. WARNING: Allowing the starter to constantly crank will damage the starter!
If the engine does not start after two attempts, refer to the TROUBLESHOOTING
section for help.
7. Once the engine has started, move the choke to “OPEN” -or- “RUN”.
Starting the Engine (Gasoline engine - Recoil start)
1. Complete steps 1 through 5, from above.
2. Grasp the recoil handle and slowly pull until resistance is felt. Pull swiftly to start the
engine. If the engine does not start after two pulls, squeeze the gun trigger to release
stored pressure.
3. Once the engine has started, move the choke to “OPEN” -or- “RUN”.
NOTE:
Allow engine to warm for 1-2 minutes before using the product.
Loading ...
Loading ...
Loading ...