Loading ...
Loading ...
Loading ...
Page 26
NOTICE
Pressure washing with volatile, ammable, or corrosive liquids could cause pressure
washer damage, re, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, ammable, or corrosive liquids, and NEVER use bleach.
VOLATILE LIQUIDS
HOW TO APPLY CLEANING SOLVENTS (if equipped)
Applying cleaning solvents and soaps is a low-pressure operation. NOTE: Only use
solvents, detergents and soaps that are designed for use in pressure washers.
DO NOT use bleach, caustic or ammable solutions!
1. Ensure that the outboard soap injector is connected to the washer high-pressure
output. (Fig. 1)
2. Place the ltered end of the siphon hose into container holding cleaning detergent.
3. If the engine is running, make sure the trigger lock is in the locked position before
removing and installing nozzles.
5. (If equipped) turn the soap control valve counterclockwise to increase soap output
and clockwise to decrease soap output.
6. After use of cleaning agents, place the chemical siphon hose into a container of
clean water. Draw the clean water through injection system to rinse it throughly. If not
rinsed throughly, the injection system can clog from dried detergent.
4. Insert the black, low-pressure nozzle into the
quick connect tting of the spray wand, see How
to Use The Spray Wand (pg. 20) section of this
manual for more information.
Fig. 1
Siphon hose
Soap injector
High-pressure
washer connector
High-pressure hose
connector
Loading ...
Loading ...
Loading ...