Loading ...
Loading ...
Loading ...
Page 40
HOT WATER OPERATION
WARNING:WARNING:
The surfaces around the burner exhaust and the discharged exhaust are VERY HOT.
Keep away from this area. DO NOT allow the hoses to contact the burner exhaust in
anyway. DO NOT allow children to operate or be in the vicinity of the pressure washer at
any time.
RISK OF BURNS
FILLING THE BURNER FUEL TANK
STARTING THE BURNER
WARNING:WARNING:
The burner will shuto every time you release the trigger. DO NOT use the pressure
washer if the burner fails to shut o when the trigger is released.
RISK OF EXPLOSION
1. Check fuel with the engine o and the pressure washer on a level surface.
2. Remove the fuel cap to verify the fuel level. For the fuel cap location, see the
COMPONENTS LOCATION section of this manual.
3. Use fresh, high-quality #2 diesel
fuel for the burner. Fill the tank to a
maximum of 1” below the ller neck
to allow room for expansion.
Maximum fuel level
4. Replace the fuel cap. Never run
the engine or pressure washer
without the fuel cap(s) installed.
1. Complete the steps in the OPERATING CHECKLIST, CONNECTING HOSES and
PURGING AIR FROM THE PUMP sections of this manual before turning on the motor.
2. Start the engine as outlined in STARTING THE ENGINE section of this manual.
3. Place the burner ON/OFF switch in the ON position.
4. (If equipped) Turn the thermostat to the desired temperature.
BURNER RESET
TEMPERATURE
CONTROL
OFFOFF
ONON
OFF
248
120
220
105
200
90
180
75
160
140
60
120
45
100
86
30
F
C
o
o
Burner ON/OFF
switch
Optional
temperature control
Loading ...
Loading ...
Loading ...