Loading ...
Loading ...
Loading ...
Page 31
DIESEL ENGINE
Fuel
Add fuel to the pressure washer by following these steps:
1. Check fuel with the engine o and the pressure washer on a level surface.
2. Remove the fuel cap to verify the fuel level. For the fuel cap location, see the
COMPONENTS LOCATION section of this manual.
3. Use fresh, high-quality #2 diesel
fuel for the engine. Fill the tank to a
maximum of 1” below the ller neck
to allow room for expansion.
Maximum fuel level
4. Replace the fuel cap. Never run
the engine or pressure washer
without the fuel cap(s) installed.
RISK OF ACID BURNS
DANGER:DANGER:
BATTERY CONNECTIONS (if equipped)
The pressure washer does not come with a battery. You must install a Group 24 -OR-
U1 sized battery before using the pressure washer.
See your pressure washer to determine the size required as indicated below.
1. Remove the cover from the battery box (if applicable).
2. Carefully place the battery into the battery box or battery holder.
3. Place the red, positive (+) battery cable onto the positive (+) battery post. Tighten.
4. Place the black, negative (-) battery cable onto the negative (-) battery post. Tighten.
5. Tighten the battery holder or place the cover back onto the battery box.
WARNING! Always remove the black, negative (-) battery cable rst and always
connect the black, negative (-) battery cable last.
Battery style Group 24 Battery style U1
Loading ...
Loading ...
Loading ...