Hikvision DS-K1T342MX-E1 User Manual

Loading ...

Click Conguraon → Access Control → RS-485 .

Check Enable, and set the parameters.

Peripheral Type

Select a peripheral from the drop-down list according the actual situaon. You can select from

Card Reader, Extension Module, or Access Controller.

Note

Aer the peripheral is changed and saved, the device will reboot automacally.

RS-485 Address

Set the RS-485 Address according to your actual needs.

Note

If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set

the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address

according to the door No.

Baud Rate

The baud rate when the devices are communicang via the RS-485 protocol.

Output Type

If you select Access Controller as the peripheral type, you should set the parameter. The device

will output the card No. or the employee ID to the access controller.

Click Save to save the sengs.

Set Wiegand Parameters

You can set the Wiegand transmission direcon.

Steps

Note

Some device models do not support this funcon. Refer to the actual products when conguraon.

Click Conguraon → Access Control → Wiegand Sengs .

DS-K1T342 Series Face Recognion Terminal User Manual

130

Loading ...

Hikvision DS-K1T342MX-E1 Face Recognition Terminal