Loading ...
Loading ...
Loading ...
troubleshooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE TROUBLESHOOTING YOUR BAND SAW.
TROUBLE
Motor wiB not run.
Blade does not run in the
approximate center of the
upper wheel.
Blade does not run in thei
approximate center of the
lower wheel.
Band Saw slows down
when cutting.
B_ades breaking.
PROBABLE CAUSE
1. Defective On-Off switch.
Defective switch cord.
Defective switch box receptacle.
2. Motor Defective,
1, Not tracking properly.
1. Upper wheel not positioned
correctly on shaft.
1. Cutting too small a radius.
2. Dull blade.
1. Too much tension.
2. Kink in blade caused by cutting
too small a radius or turning the
material too fast when cutting,
REMEDY
1. Replace defective parts before using
Band Saw again.
2. Consutt Sears Service. Any attempt to repair
this motor may create a HAZARD unless
repair is done by a qualified service technician.
Repair service is available at your nearest Sears
Store.
1. Adjust tracking, see Assembly Section,
"Tracking the Blade."
1. Reposition the wheel, see Assembly
Section, "Tracking the Blade."
1. Stop feeding, and back up to the material
slightly, until the band saw speeds up.
2. Replace blade.
1. Adjust tension. See Getting To Know
Your Band Saw "Tension Setting".
2. Use correct cutting technique. See Basic
Band Saw Operation Section.
FIGURE 1
SUPPUED WITH MODEL 113.244420
J
12 a 11 tl
Key
No. Part No. Description
! I 62614
2 i 60314
2 STD541025
4 STD551225
5 68060
7 68059
8 62615
11 STD541050
12 803835
69097
Leg
t'Screw Truss Hd. 114-20 x 5iB
t_Nut Hex 1t4-20
t*Lockwasher, 1/4 External
Channel, Support
Stiffener, Side
Stiffener, End
t'Nut, Hex Hd. 1/2-13
t Foot, Leveling
*Bag of Loose Parts
HARDWARE FOR MOUNTING TOOL
STD523110 t'Screw, Hex Hd. 5/1618 x 1
STD551131 1"*Lockwasher Ext. 5/! 6
STD541231 )'*Nut, Hex 51!6-18
STD551031 T'Washer 11!32 ID
" Standard Hardware item - May Be Purchased Locally
1"Al! Parts Contained In Loose Parts Bag
19
Loading ...
Loading ...
Loading ...