Loading ...
Loading ...
Loading ...
ADJUSTING THE TABLE SQUARE TO BLADE
NOTE: The combinationsquare must be "true". Sea
startof "assembly" sectionfor checkingmethod.
1. Loosen guide bar lock screw and raise the upper
bladeguido assembly all the way up.Tighten guide
bar lockscrew.
2. Place a square on the table against the rear edge of
the blade as illustrated.
3. If adjustment is required, loosenthe two screws in
the trunnion stop brackets and tap table up or
down untiltable issquarewith blade.
4. Tighten screws.
5. Loosentable lock knob,
6. Place a square on the table against the blade as
illustrated.
7. Tilt table up or down to align table 90 degrees to
blade (0 degree position) and tighten table lock
knob.
8, Loosen the two screws in the trunnion stop brac-
kets and slide bracket under lock knob until it rests
against end of slot in trunnion,
9, Tighten scr_ews.
10. Check squareness of blade to table. Make readjust-
ments if necessary.
11. Loosen table lock knob.
12. Tilt table to 45 degree position and check using a
combination square,
13, Loosen the two screws in the trunnion stop brac-
kets and slide bracket on opposite side of lock
knob until it rests against end of slot in trunnion.
NOTE: Be careful not to change position of slide
_INATION SQUARE
TABLE LOCK KNOB
STOP BRACKET
bracket under lock knobthat set the 0 degree position. SCREWS
!4. Tighten screws.
15. Check bladeto table at the 45 degree position.
16. Loosen table lock knob and position table at O de=
gree position;recheck squareness.
17. Make readjustmentsif necessary.
ADJUSTING GUIDE BAR
NOTE Wh n " ' _'_ " _
: e the upper guiaes are raised or lowered,
they must not deflect the blade front to back or side-
ways. This means that the guide bar must be parallelto Itl _fl
the blade, rt____/_
1. Lower guide bar until it is approximately 1-3/4 I_'_ ./_(, "_---
,nchesabovetab,eT,,htanguidebar,ockscrow _
2. Hold a square on table against guide bar as shown ////Y/_ __._
to check side to sde squareness, _///_._/_/_//_j_J ___._.___._______X__\
1
12
Loading ...
Loading ...
Loading ...