Loading ...
Loading ...
Loading ...
44 Connectors
NOTICE
•
Keep the door closed to prevent dirt and moisture from entering the camera.
•
Only Sony SxS PRO and SxS PRO+ cards can be used with ALEXA. Sony
SxS-1 cards are not supported.
•
For the remainder of this manual, whenever SxS PRO is mentioned, this
applies to SxS PRO+ likewise.
•
SXR Capture Drives are specified for a temperature range from 0° Celsius to
70° Celsius (32° Fahrenheit to 158° Fahrenheit). When working in environments
with ambient temperatures below 0° Celsius, ensure that SXR Capture Drives
have a temperature of at least 0° Celsius when starting a recording to ensure
proper operation.
•
While we do everything we can to assure reliable functioning of different
recording medias such as SXR Capture Drives, and while the mean time
before failure (mtbf) for drives is excellent, a failure that results in loss of data
may occur at any time. Therefore, you are obliged to implement and maintain
at any time adequate and necessary data security measures and back up
drive content as soon as possible. ARRI assumes or accepts no liability or
responsibility for data loss or data corruption, or any other damages, loss or
harm due to malfunction of recording drives.
Inserting media:
To insert an adapter:
1. Insert the adapter into the media slot with the contacts facing the front of the
camera and the metal housing facing out (away from the camera body).
2. Push the adapter towards camera front until the two securing plastic lids lock the
adapter.
To load an SXR/XR Capture Drive:
1. Insert the SXR/XR Capture Drive into the media slot with the contacts facing the
front of the camera and the ribbed side facing out (away from the camera body).
2. Push the SXR/XR Capture Drive towards camera front until the lock engages.
3. Close the door.
When the camera is in ARRIRAW mode, it automatically loads the SXR/XR Capture
Drive when the door has been closed, see "Explanation of LED States" below. If
closing the door is not possible, e. g. because it has been damaged, loading an SXR/
XR Capture Drive can also be triggered by pressing and holding the eject button for
about five seconds.
Loading an SXR/XR Capture Drive in ARRIRAW mode normally only takes a few
seconds. In certain situations, however, it may take up to 30 seconds, especially when
an SXR/XR Capture Drive has been removed previously without unloading it properly.
NOTICE
Do not put any labels or adhesive tape on the back of an SXR/XR Capture Drive
(the side facing the camera body). The SXR/XR Capture Drive must have full
contact to the camera body to ensure proper heat conduction.
To load an SxS PRO card or CFast 2.0 card:
1. Insert the card into the adapter with the contacts facing the front of the camera and
the label facing out (away from the camera body).
2. Push the card in against the spring until the lock engages.
3. Close the door.
Loading ...
Loading ...
Loading ...