Loading ...
Loading ...
Loading ...
22 Safety Guidelines
•
Do not subject the system to severe shocks!
•
Do not place the system on an unstable trolley/hand truck, stand, tripod, bracket,
table or any other unstable support device! The system may fall, causing serious
personal injury and damage to the system or other objects.
•
Operate the system using only the type of power source indicated in the manual!
Unplug the power cable by gripping the power plug, not the cable!
•
Never insert objects of any kind into any part of the system if not clearly qualified
for the task in the manual, as objects may touch dangerous voltage points or short
out parts! This could cause fire or electrical shock.
•
Unplug the system from the power outlet before opening any part of the system or
before making any changes to the system, especially the attaching or removing of
cables!
•
Do not use solvents to clean!
•
Do not remove any stickers or paint marked screws!
•
Always place a lens or a protective cap in the lens mount receptacle!
•
Never run a camera with a mirror shutter without a lens or a protective cap in the
lens mount receptable!
•
Changing camera lenses should be done in a dry and dust-free environment. If
this is not possible, take extra care that no dust enters the camera while the lens is
off!
•
When no lens is attached to the camera, immediately place the protective on the
lens mount to avoid contamination of the sensor cover glass!
•
After changing lenses, always perform a dust check to make sure no dust has
settled on the sensor cover glass!
•
Clean optical lens surfaces only with a lens brush or a clean lens cloth. In cases of
solid dirt or grease, moisten a lens cloth with pure alcohol. Discard contaminated
lens cloth after use! Never attempt to clean a lens brush with your fingers!
•
NEVER USE CANS WITH COMPRESSED AIR OR GAS TO BLOW OFF THE
DUST! This can severely damage optical elements.
•
If the sensor cover glass has been contaminated by solid dirt or grease, special
optical cleaning kits should be used for dirt removal under very high care! If the
contamination cannot be removed, the camera should be taken to an ARRI service
center for cleaning.
•
THE USE OF METHANOL TO CLEAN OPTICAL SURFACES IS NOT
RECOMMENDED!
•
NEVER USE ACETONE TO CLEAN OPTICAL SURFACES!
•
NEVER TRY TO REMOVE THE SENSOR COVER GLASS!
•
DO NOT POINT THE CAMERA INTO DIRECT SUNLIGHT, VERY BRIGHT LIGHT
SOURCES, OR HIGH-ENERGY LIGHT SOURCES (e.g. laser beams)! This may
cause permanent damage to the camera image sensor.
•
DO NOT POINT THE VIEWFINDER INTO DIRECT SUNLIGHT, VERY BRIGHT
LIGHT SOURCES, OR HIGH-ENERGY LIGHT SOURCES (e.g. laser beams)!
This may cause permanent damage to the viewfinder display and optical
elements.
•
During extended operation, high data rates and/or operation at high ambient
temperatures, the camera's surfaces and especially the area around the
ventilation grille on top of the camera at the camera rear can get hot. Use caution
and never cover, obstruct or block the fan inlets or outlets while the camera is
powered.
Loading ...
Loading ...
Loading ...