Loading ...
Loading ...
Loading ...
154 ALEXA SXT W
Pairing:
1. Make sure the transmitter and receivers you want to pair are at least 1 m apart.
2. Turn on WVR-1. Make sure no other transmitters and receivers are powered up.
3. Press PAIR on WVR-1 until NETWORK LED blinks fast.
4. Press PAIR on the camera until NETWORK LED blinks fast.
5. Pairing is complete when NETWORK LEDs turn to solid.
6. Repeat the procedure for each additional WVR-1.
During the pairing process, the external monitor to which the WVR-1 is connected
should show the following information:
1 "Registration in Progress"
2 "Searching for Camera Unit ..."
For instructions on pairing the camera with a Transvideo Starlite ARRI-WVS, please
see the manual of the Transvideo Starlite ARRI-WVS.
NOTICE
If four receivers are paired to a transmitter, and another receiver is paired, the first
of the already paired receivers will be unpaired and the new one will be added. The
adding of new receivers works in a cyclic first-in first-out order.
An inactive receiver stays paired to the transmitter. If a fifth receiver is added to
a setup with one inactive and three active receivers, the new receiver does NOT
replace the inactive one. In this case, there is no differentiation between active and
inactive devices. The rule mentioned above still applies.
NOTICE
Before pairing two devices, make sure that there is at least 1 meter / 3.3 feet
distance between the devices.
16.2.4 Supported resolutions
1080p 23.976, 24, 25, 29.97, 30, 50, 59.94, 60
1080i 48, 50, 60
1080psf
•
23.967 (displayed as 1080i48)
•
24 (displayed as 1080i48)
•
25 (displayed as 1080i50)
•
29.97 (displayed as 1080i60)
•
30 (displayed as 1080i60)
Loading ...
Loading ...
Loading ...