Loading ...
Loading ...
Loading ...
Connectors 41
10.8 RS
The two RS connectors supply external accessories with at least 24 V power and a
combined load of up to 2.2 A (shared with the EXT connector power out). The sockets
also accept an ARRI remote start/stop trigger.
The connectors are located at the front of the camera on the camera-right side.
10.9 12 V
The 12 V connector supplies an external accessory with 12 V power and up to 2.2 A
current.
The connector is located at front of the camera on the camera-right side.
10.10 TC
The TC connector is a 5pin LEMO socket. It accepts and distributes a Longitudinal
Time Code (LTC) signal.
It can be used to
•
jam-sync the ALEXA's time code to a Clockit, TC Slate or another camera
•
transmit the ALEXA's time code to a Clockit, TC Slate or another camera
•
tune the frequency of the ALEXA’s crystal oscillator with an Ambient ACC Clockit
Controller
The connector is located at the front of the camera on the camera-right side.
Note that during playback, the timecode that is output via the TC connector does not
match the timecode of the played clip.
10.11 AUDIO OUT
The AUDIO OUT is a 3.5mm TRS connector (headphone jack), which outputs audio
fed to the 5-pin XLR AUDIO IN connector with a maximum power of 2.5 dBm.
The connector is located at the front of the camera on the camera-right side.
NOTICE
Connecting headphones to the camera while recording can cause a short audio
signal interruption due to static electricity.
10.12 SD Card
The ALEXA saves data such as user setups, frame grabs and system logs to an SD
card. Firmware, additional frame lines and ARRI Look File 2 files are loaded onto the
camera from the SD card. The SD card slot is located on the bottom of the camera on
the camera-right side. To access the SD card slot, slide the door towards the front of
the camera.
SD Card Requirements
•
SD or SDHC card (most brands are compatible)
•
maximum capacity of 4GB
•
FAT or FAT32 format
Loading ...
Loading ...
Loading ...