Loading ...
Loading ...
Loading ...
9
3
does not run.
2.The function switch wiring
is loose.
2.The function switch cable
should be reconnected.
3.The contactor is bad.
3.Replace the contactor.
4.There is a problem with the
PCB.
4.Replace the PCB board.
5.Capacitor Failure (220V
series)
5.Replace the capacitor.
6.The compressor is bad.
6.Replace the compressor.
4
Not Cooling
1.Refrigerant Leak
1.Repair the leak position and
vacuum the refrigerant.
2.Condenser is blocked.
2.Clean the condenser.
3.The fan does not work.
3.Repair or replace the fan.
5
Can't make ice
cream
1.No material in the cylinder.
1.Add slurry to the cylinder.
2.Unloading puffing tube is
blocked.
2.Pull out the puffing tube and
clean it up.
3.The slurry ratio is wrong, too
thick.
3.Reconstitute the qualified
slurry.
4.The panel travel switch is
damaged or disconnected
4.Reconnect the line or replace
the travel switch.
5.There is a problem with the
reducer.
5.Repair or replace the gear unit.
6
Poor Expansion
1.Expanded tube is not
inserted.
1.Reinsert the expansion tube.
2.No open puffing switch.
2.Turn on the puffing switch.
7
Ice cream is too soft
1.Slurry ratio is wrong.
1.Reconstitute qualified slurry.
2.Improper hardness setting.
2.Reset hardness.
3.Motor current is large, there
is a short circuit.
3.Repair or replace the motor.
8
Ice cream is too
hard
1.Too much water in the
ingredients
1.Reconstitute qualified slurry.
2.Improper hardness setting.
2.Reset hardness.
10
Material Leakage
1.Discharge Valve Leakage
1.Replace the discharge valve
seal.
2.Leakage at the rod.
2.Replace the stem seal.
3.Leakage at the leak.
3.Replace the outlet valve seal.
4.Stirring shaft seal rupture.
4.Replace the seal.
11
The compressor
stops after the ice
cream is formed,
and the motor does
1.Travel switch contacts are
attached.
1.Repair or replace the travel
switch.
Loading ...
Loading ...