Loading ...
Loading ...
Loading ...
8
tank of the machine. If the drain pipe has liquid such as raw materials, it may be
caused by a defective motor shaft in the deep part of the freezing cylinder, so
please contact the store or maintenance personnel.
Note: Please do not use polishing powder, gasoline, hot water, etc., otherwise
it will damage the outer surface of the machine.
Please do not use water directly to avoid leakage or accidents.
If the power cord is damaged, do not use it. Please check it once or twice a
month. Check if there is any damage.
IV. Cleaning and Maintenance of the Condenser
During the working period, the condenser will be covered with dust, which will affect
the heat dissipation. The cooling effect is poor. It must be cleaned every two months.
It is best to clean it with professional personnel. Always cut off the power before
cleaning, and do not damage the condenser fins.
Annex
1. Consumable Parts:
Seal O Ring 1 set; Scraper 2 Pieces; Cleaning Brushes 1 Set
2. Hex Wrench 1 Piece;
3. Manual;
4. Warranty Card;
Fault Analysis and Solutions
No.
Fault
Phenomenon
Cause
Method
1
The machine does
not start.
1.The power cord is not
connected.
1.Check the power cord and
connect it.
2.Zero line is not connected.
2.Check the neutral line and
connect it.
3.The control power switch is
not turned on.
3.Turn on the control power
switch.
4.The control power switch
connection problem.
4.Reconnect the control power
switch.
5.There is a problem with the
PCB.
5.Replace the PCB board.
2
Cleaning function
does not work.
1.Loose connection.
1.Reconnect.
2.Motor or capacitor is bad.
2.Repair or replace the motor or
capacitor.
3.The contactor is bad.
3.Replace the contactor.
The compressor
1.Low voltage.
1.Check the supply voltage.
Loading ...
Loading ...
Loading ...