Loading ...
Loading ...
Loading ...
4 Click AppleTalk.
5 Select the printer from the list.
6 Click Add.
In Mac OS X version 10.4 and earlier
1
From the Finder desktop, choose Go > Applications.
2 Double‑click Utilities.
3 Double‑click Print Center or Printer Setup Utility.
4 From the Printer List, click Add.
5 Choose the Default Browser tab.
6 Click More Printers.
7 From the first pop‑up menu, choose AppleTalk.
8 From the second pop‑up menu, choose Local AppleTalk zone.
9 Select the printer from the list.
10 Click Add.
Note: If the printer does not show up in the list, you may need to add it using the IP address.
Contact your system support person for assistance.
Changing port settings after installing a new network
Internal Solutions Port
When a new network Lexmark Internal Solutions Port (ISP) is installed in the printer, the printer
configurations
on computers that access the printer must be updated because the printer will be assigned a new IP address.
All computers that access the printer must be updated with this new IP address in order to print to it over the
network.
Notes:
• If the printer has a static IP address that will stay the same, then you do not need to make any changes
to the computer
configurations.
• If the computers are
configured
to print to the printer by a network name that will stay the same, instead
of by IP address, then you do not need to make any changes to the computer configurations.
• If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure
the wired network is disconnected when you configure the printer to operate wirelessly. If the wired
connection remains connected, then the wireless configuration will complete, but the wireless ISP will
not be active. In the event that the printer was
configured
for a wireless ISP while still attached to a wired
connection, disconnect the wired connection, turn the printer o, and then turn the printer back on
again. This will enable the wireless ISP.
• Only one network connection at a time is active. If you want to switch the connection type between
wired and wireless, you must first turn the printer o, connect the cable (to switch to a wired connection)
or disconnect the cable (to switch to a wireless connection), and then turn the printer back on again.
For Windows users
1 Print a network setup page and make a note of the new IP address.
2 Click , or click Start and then click Run.
Additional printer setup 50
Loading ...
Loading ...
Loading ...