Loading ...
Loading ...
Loading ...
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
11
Installation (Cont.)
Earthing
WARNING: This is a Category I electrical product which must be earthed.
In the event of a malfunction or breakdown, earthing will reduce the risk of an electric
shock by providing a path of least resistance for the electric current. This appliance is
equipped with a cord having an equipment-earthing conductor and an earthing plug.
The plug must be plugged into an appropriate outlet that is installed and earthed in
accordance with all local requirements.
Ensure the outlet is properly earthed to the ground. If unsure, consult a qualified
electrician or a service representative. Do not, under any circumstances, cut or
remove the third grounding prong from the power plug. We accept no liability for
damage to the appliance or personal injury resulting from failure to observe any
electrical connection procedures.
Electrical connection
Before plugging in your new heat pump dryer, check and ensure the power supply
system (current, power voltage and wire) at your home can meet the normal loading
requirements of electrical appliances. The electrical voltage and circuit frequency are
listed on the appliance rating label.
Do not kink or damage the power cord, and position it out of the way so no one steps
on or places anything on the cord or against it.
Ensure the dryer is unplugged from the power supply before installation. The plug
must be accessible after installation.
CAUTION: Do not use a power adaptor or extension cord.
Unless your home is already fitted with a residual current device (safety switch), we
recommend installing an RCD with a rated residual operating current not exceeding
30 mA to provide additional safety protection when using electrical appliances. See
your electrician for professional advice.
All electrical connections must be made by qualified personnel, and all instructions in
this manual as well as local safety regulations must be observed.
Once the heat pump dryer is properly installed, plug the electrical cord into an
appropriately earthed three pin wall socket, switch on power at the socket and try the
machine (see page 17 for trial usage instructions).
Loading ...
Loading ...
Loading ...