Loading ...
Loading ...
Loading ...
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
10
Installation (Cont.)
Levelling the appliance
The appliance must be installed level, otherwise its operation will be impaired. When
you have placed the dryer in its permanent position, press on the top frame (in both
directions) to ensure the appliance is level: it should not shake or wobble. Alternatively,
use a spirit level to ensure the appliance is level.
If your floor is slightly uneven, adjust one or more of the levelling feet to ensure level
installation. The levelling feet are located underneath each corner
Turn the feet anticlockwise to lower the appliance, or clockwise to raise it (Fig. 2).
WARNING: Never remove the feet of the appliance, which would restrict the floor
clearance required.
Fig. 3
Fig. 2
Drain hose installation
The heat pump dryer does not need to be vented, so you do not need to install an
air duct. However, the appliance produces condensate water which is by default
collected in the in-built water container and needs to be emptied after use.
Alternatively, you can drain the water into a nearby sink using an external drain hose
(supplied). If you want to drain the condensate water directly into a sink, install the
drain hose as follows:
Pull the water pipe in arrow direction from the hose connector at the back of the
appliance, using pliers if necessary (Fig. 3). Install the external drain hose to the hose
connector and lead the end into a standpipe or sink.
Loading ...
Loading ...
Loading ...