Loading ...
Loading ...
Loading ...
Safety Tips
7/21
Number: JT190199988 Version Number: A1
Note: Subsequent versions of this specification are subject to change without prior notice. Thank you
Ice Maker Operation
10. Operation
10.1 Power on/off
Power on: connect water supply and
drainage, plug in power plug, display screen is
all bright;
Power off: press "power" key, ice machine
into standby state, digital tube display
"OFF", and then pull out the power plug.
10.2 Ice thickness regulation
Ice thickness adjustment: press the thick (or
thin) button for 5 seconds, Before the digital
display C1, The last two started flashing,
Enter the ice thickness setting state. At this
point, Press the thick (or thin) button every
time, Digital display increases (or
decreases)1, indicates an increase (or
decrease) in ice-making time for 1 minute,
Adjust the range to 0~35 minutes. If you
don't press the button in 10 minutes, Then
the digital stops flashing, Into normal
operation, The ice thickness set at the
same time is saved.
10.3 Forced de-icing
Forced deicing: in the state of ice making,
press the status "key to start forced deicing.
10.4 Manual cleaning
At any time press "cleaning" key, enter the
cleaning state, only pump work, screen
display start timing, about 30 minutes later,
cleaning stop, protection shutdown;
Note: if you need quick cleaning, you
can not wait 30 minutes to press
"cleaning" into the rinsing stage, rinsing
if you do not need to cycle many times
can press "power" key to stop rinsing,
into standby state;
Loading ...
Loading ...
Loading ...