Loading ...
Loading ...
Loading ...
Safety Tips
15/21
Number: JT190199988 Version Number: A1
Note: Subsequent versions of this specification are subject to change without prior notice. Thank you
Cleaning and Disinfection
Water between the tank and evaporator has
been circulating cleaning, about 30 minutes
later, the cleaning stopped, manual
discharge of water in the tank;
5. Press "[ cleaning]" key again, enter
automatic rinsing stage, tap water rinsing
process cycle 2 times, then rinse cycle with
pure water 3 times, the whole cleaning
process is over, the screen shows "OFF",
about 37 minutes after the whole cleaning
process is over ," The screen shows OFF", in
standby and unplug.
6. Note: after cleaning and disinfection, start
making ice, the first 5 plates of ice discarded,
do not eat.
14.3 Removal/installation process of parts
a．When removing the pipe, remove "pull out"
clamps "and" upper pipes "(as shown):
Pull out the hose
Unplug pipe
a. Remove two screws
b．
Spin out the plastic cover and remove the
plastic mandrel
Note: when the pipe is assembled, the pipe hole
position and mandrel hole position direction
should be opposite, must not be the same
direction, the correct diagram is as follows:
c． Disassemble and assemble the baffle: grasp
the middle position of the baffle and use a flat
screwdriver to force from one side to the other
until one side of the baffle is removed from the
pin hole.
Loading ...
Loading ...
Loading ...