Loading ...
Loading ...
Loading ...
li+_h'P,_l,11-+-'il_I"
Select ANGLE TO WALL OR CORNER if this unit is
installed in the corner in your listening room. Adjust
the width and length of your listening morn as well as
the distance of the listening position from this unit and
the distance of the center of this unit from the left wall.
Listening position
from the unit
Room widtl"
,4
Room length
Choices for tile morn width and length:
2.0 m to 12.0 m (6.5 ft to 40.0 ft)
Choices l\_r the listening position from this unit:
2.0 m to 9.0 m (6.5 ft to 30.0 ft)
Choices l\_r the listening position from the left wall:
0.6 m to 11.4 m (2.0 ft to 38.0 It)
Room width and length
Listening position from
the unit and the left wall
+
pi,,,==r+,"('¢TL ==, r"i==t+l==iM.,"=,-(r=r.l==
7+7
H,C',li i ihi2 r,HffHi'!',li U_,},:,',"',:,,
. 3m
%
Eli _[T] : Up _Dokln£_l],[b] :5e I
[EblTER] : Ret urr,
When you set the INSTALLED POSITION parameter in BASIC
SETUP (see page 59) or MANUAL SETUP (see page 65). the
parameters newly set lbr the width and length of your listening
room are autonmtically set as the factory default vahm.
• BEAM ADJUSTMENT(Beam adjustment)
Use to manually adjust the various speaker beam angles.
We recommend that you select 5 beam mode before
adjusting these parameters.
• When INSTALLED POSITION is atlinsted in BASIC SETUP
(see page 59) or MANUAL SETUP (see page 65), the factory
default value is automatically set for this parameter except when
FOCAL LENGTH is set to CENTER (see page 67).
• Depending on the beam mode settings (see page 40), some
speaker positions may not be available for selection. In this
case. " -' is displayed. When using the stereo plus 3 beam
mode. set the surround left and right signals to be output from
the front lell and right speakers.
rl',,r r=+%_==it+,?+':=T+,!r%lT
E_,,E,gH,, HL,'dt+!2,ii'lgi'ii
+ a)HORIZONTI:IL ANGLE
B,>BEI:IH TRAt)EL LENG'rH
,s>FmML LENGTH
d>TREE=LE G_IIN
[i] ,[ _] :IJp,Dol,Jn
[SELECT ]:Enter
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each
speaker. By adjusting the horizontal angle of the beams,
you can optimize the sound beam paths. A test tone is
automatically output.
( : :+)
(+)
Choices: L90 ° to R90 °
Adjust towards L (left) to move the direction of the output
to the left and adjust towards R (right) to move it to the
right.
=',,H=%'=iT"_+=iLI%=II ++ILj=",IY I ,_
,+%+Mt+,m,i,,:St++l'!+HLN'ItSLBi,"d
3BEAP'I
FPoh_ L
L.66deg L96 _ RgO
I
8(deg>
[_] IT] :IJP +[/ol IR[_1 ] +[I_] : Sel
[ENTER] :Ret uPn
66
Loading ...
Loading ...
Loading ...