Loading ...
Loading ...
Loading ...
12 English
Installation
Installation
7. Remove the cover by loosening the
screw on the PCB cover.
8. Connect the connector of the electric
damper wire and the PCB connector.
NOTE
Insert the wire into the hole at the top
left corner.
9. Assemble the PCB cover using a
screw.
NOTE
Put the connected connector into the
hole of the cover as shown in the
picture.
Connecting the Vent System
NK3*CB600W**
5. Assemble the damper or the electric
damper for preventing backflow by
turning it in to the hood exhaust
outlet.
NOTE
• Damper is provided in NK3*CB600W**.
• Electric Damper is provided in
NK3*CB700W**.
CAUTION
Check that the electric damper is seated
correctly on the screw thread and there
is no tilt. If the electric damper is not
flush, air will leak through the gap.
NK3*CB700W**
6. Assemble the damper adapter,
pushing it into a damper or electric
damper. Fix it using tape.
NOTE
• If the hood is NK3*CB600W**,
please follow it from No.10.
• If the hood is NK3*CB700W**,
please follow it from No.7.
Loading ...
Loading ...
Loading ...