Loading ...
Loading ...
Loading ...
IN THE COMMONWEALTH OF
MASSACHUSETTS
•This product must be installed by a licensed plumber or gas
fitter.
• When using ball type gas shut-off valves, they shall be the
T-handle type.
• A flexible gas connector, when used, must not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conibrm with local codes, or
in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA.54, latest edition. In Canada,
installation nmst conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1 or the current Propane
Installation Code, CAN/CGA-B149.2, and with local codes
where applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest edition
and Canadian Gas Association according to CAN/CGA-I.1
latest edition.
As with any appliance using gas and generating heat, there
are certain safety precautions you should tbllow. You will
find these precautions in the Important Safety Inlbrmation
section in the front of this manual. Read them carefully.
• IMPORTANT - Save these instructions for local
electrical inspector's use.
• IMPORTANT - Observe all governing codes and
ordinances.
_ffl'li T0 INSTI\I.I.rlI.
Leave these instructions with the appliance after
installation is completed.
_l)'l'liTI)(,IINSIINI:II:
Keep this Owner's Manual and Installation Instructions
for future reference.
_!!'l'li: This appliance must be properly grounded.
• The electrical diagram is in an envelope attached to the
back of the range.
• Skill level - Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of
this or any other appliance.
If you smell gas:
I.Open windows.
2. Don't touch electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-blade screwdriver Open-end or
adjustablewrench
Penciland ruler
Level
Pipe wrench(2)
(onefor support) Drill, awl or nail
MATERIALS YOU MAY NEED
•Gas line shut-off valve
•Pipe joint sealant or UL-approved pipe thread tape with
Teflon _ that resists action of natural and LP gases
• Flexible metal appliance connector (1/2" I.D.) A 5-ibot
length is recommended ibr ease of installation but other
lengths are acceptable. Never use an old connector when
installing a new range.
• Flare union adapter ibr connection to gas supply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare union adapter ibr connection to pressure regulator on
range (1/2" NPT x 1/2" I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2" O.D. sleeve anchor (ibr concrete floors
only).
_Teflon: Registered trademark of DuPont
iiii>_
iii ',<
ii!i..............................
-39-
Loading ...
Loading ...
Loading ...