Loading ...
Loading ...
Loading ...
920-087-04(8-05)
ExtemalDrain(for newconstructionor unitreplacement)
When using an external drain system, the condensate is removed through either of two drain holes on the back of the wall sleeve.
Select the drain hole which best meets your drainage situation and install the drain kit. Seal off the other with a cover plate.
Drain Tube Installation
1. Peel the backing tape off the gaskets and apply the
sticky side to one cover plate and one mounting plate
as shown in DetailsA and B.
2. Placethedraintubethroughthegasketandthemounting
plate with theflange toward the wall sleeve.
Attach the drain tube assembly to one of the two drain
holes at the rear of the wall sleeve. The large flange
on the mounting plateis positioned atthe bottom ofthe
sleeve facing toward the sleeve, Detail B. When the
drain tube ispositioned atthe desired angle,tighten the
screws.
NOTE:
If the wall sleeve has not been installed, the drain tube
must be rotated to a horizontal position until after the
sleeve is installed. Tighten the mounting plate screws
when the tube is in the proper position. Make certain
that thefour overflow slots atthe rear ofthe wall sleeve
are not blocked. (See the drawing below.)
Cover Plate Installation
4. Mount the foam gasket to the cover plate. Using two
#10 x 1!2" sheet metal screws (provided), attach the
cover plate to the remaining drain hole. Make certain
the largeflange on the plate is positioned at the bottom
of the sleeve.
5. Discard the additional cover plate, gasket, machine
screws, and Iocknuts.
QUANTITY DESCRIPTION
2
1
1
3
4
2
2
COVER PLATES
MOUNTING PLATE
DRAIN TUBE
MOUNTING PLATE GASKETS
#10X 1/2" MOUNTING SCREWS
10-24 X 1/2" MACH. SCREWS
LOCKNUTS
Figure4
DrainKitInstallation
-- Foam gasket
Mounting plate
DETAIL A
I V2" O.D. tube
Foam gasket _ /
Mounting plate # 10 sheet metal screws
DETAI L B
NOTES:
The large flange on the mounting plate is positioned atthe bottom of the sleeve facing toward the sleeve. The drain tube must be rotated to a horizontal
position to allow for the wall sleeve to be installed into the wall. Once the wall sleeve is installed, return the drain tube to a downward angle.
Loading ...
Loading ...
Loading ...