Loading ...
Loading ...
Loading ...
920-087-04 (8-05)
4. Center the chassis in the pre-installed sleeve and carefully
pushthe chassis untilthe chassisflange andgasket contact
the sleeve flange.
®
Wall sleeve
j Wall sleeve flange
Chassis flange
and gasket
them intothe quick nuts located on the chassis to secure
the cover. If the unit hasbeen placed such that there is no
room to insert thethumbscrews from the bottom, request a
Side Mounting kit (Part No. PXSM) from Friedrich. Locate
the service cord or conduit in the notch atthe bottom right
of the front cover.
®
7. Ifthe filters are not already installed in tracks in the plastic
cover, slidethem into place.
NOTE: If the unit ismounted flush to the floor, the service cord
MUST be rerouted at the bottom of the front cover on the side
closest to the receptacle. A notch MUST be made in the front
cover sidewhere thecord exitsthe unit. Itis the responsibility of
the installer tocreate anexit notch. See diagram8 for suggested
opening size and placement.
®
mounting screw
Screw clips
Chassis
flange
5. Locate the four#10 x 1"chassis mounting screws. Tighten
thescrews intotheclips - adjacentto thealignment dimples
on the mounting brackets on the wall sleeve flange (two
per side).
6. Install the front cover assembly (including the discharge
grille) by placing the top of the cover onto the 90° angle
bracketalong the topofthe chassis. Rotatethe bottom into
place and insert the included thumb screws into the slots
located at the bottom back corners of the cover. Tighten
8. Plugthecord (ifapplicable)into theappropriate receptacle.
Extra cord may be coiled inside the front cover behind the
return air grille. Restore power to the unit.
®
To remove the front cover, remove the thumbscrews
at the bottom back corners of the cover (or sides).
Pull the bottom end forward and lift it up to clear the
L bracket across the top of the chassis,
®
Not to scale
Ifa remotethermostatistobeinstalled, proceedto page 18, Step1, Fora 265 V unit,proceedto AppendixA,Step 1.
15
Loading ...
Loading ...
Loading ...