Loading ...
Loading ...
Loading ...
920-087-04 (8-05)
InstallationChecklist
[] Inspect all components and accessories for damage
before and after installation.
[] Remove the cardboard wall sleeve support and grille
weatherboard.
[] Check for proper wall sleeve installation in accordance
with thewall sleeve installation instructions.
[] Check for a subbase kit or other means of structural
support which is required for ALL installations projecting
more than 8" into room.
[] Installthe recommended Condensate Drain Kits for
complete condensate removal.
[] Ensure that the chassis is installed in a 16" high x 42"wide
wall sleeve that is no deeper than 13 3/4". A baffle kit is
required ifthe sleeve exceeds that depth.
[] Ensure that drapes, bed, bedspread, furniture, etc. DO
NOT block either returnor discharge air grilles.
[] Inspect the condenser air inlet andoutlet for any
obstructions (shrubbery, etc.)
[] Ensure that'reset' button is pressed on LCD device (only
on cord connected models)
Section III - ChassisInstallation
Checktobesurethewallsleeve,extension(ifused),grille,anddrainkitareinstalledproperlybeforechas.,isinstallation.
1. Removetheweatherboardand centersupportfromthesleeve
(ifstillin place).Besure an outdoorgrille isattached.
Wall sleeve
NOTE: Toavoid breaking the door or hinge pins, do not apply
excessive force when installing
®
Pins
--Weatherboard
Center support
IMPORTANT:Useawallsleeveadapterkit(PXSE)if
installinga P-Serieschassis ina T-Seriessleeve.
Suffocation hazard
Keep bag away from babies and children.
Do NOT use in cribs, beds or playpens. Destroy
immediately after opening. This bag is NOT a toy.
Failure to do so can result in personal injury and/or death
" Control
Door
i
J
Front Panel
3. Remove the two chassis shipping brackets from the ends
of the shipping pallet.
®
Compressor
Chassis
shipping bracket
Shipping pallet
2. Removethefront covercontained in a protectiveplasticbag
from chassis. Remove the bag anddispose of itproperly.
If the control door is not installed, follow these steps:
From the front of the cover, slide the right control door pin
into the hole on the right side of the front cover. Slide the
left door pin into the hole on the left side of the front cover
opening and snap it into place.
14
IMPORTANT: When installinga FriedrichP-Series PTAC intoan
existing sleeve, it is important to ensure that the unit is installed
completely. Inspection ofthe air seal between the condenser air
baffles and around the indoor mounting flange isrecommended.
In some cases additional gaskets or baffling may be required.
Loading ...
Loading ...
Loading ...