Loading ...
Loading ...
Loading ...
CUSTOMER RESPONSIBILITIES
Some adjustments will need to be made periodically to
properly maintain your snow blower.
Atl adjustments in ADJUSTMENTS/REPAIRS section of this
manual should be checked at least once each season.
SNOW BLOWER
The following adjustment should be performed more than
once each season.
Auger and Traction Drive Belts should be adjusted after the
first 2 to 4 hours of use, again about mid-season and twice
each season thereafter (See To Adjust Belts paragraph in the
Adjustment/Repair section).
AS REQUIRED
Auger Gear Box
The auger gear box is lubricated at the factory and should not
require additional lubrication.
If for some reason the lubricant should leak out, or if the auger
gear box has been serviced, add Lubriplate GR132 Grease
or equivalent. Maximum 3-1/4 ounces, (92 grams) should be
used.
Remove filler plug D (Figure 22 and Figure 23), once a year.
If grease is visible, do not add. If grease is not visible, use a
piece of fine wire, like a dipstick to check if there is grease in
the gear box. Mobitux EP1 and Shell Atdania EP1 are
suitable equivalents.
D
Filler
Plug
Figure 22
Figure 23
LUBRICATION AT STORAGE
Bearings and bushings
All bearings and bushings are lifetime lubricated and require
no maintenance.
Hex shaft and chains
For storage hex shaft should be wiped with a cloth lightly
moistened with motor oil to prevent rusting (see Figure 25).
For storage chains should be lubricated with a chain type
lube. (see Figure 25).
NOTE: Any greasing or oiling of the above mentioned
components can cause contamination of the rubber
friction wheel. If the disc drive plate or friction wheel
come in contact with grease or oil damage to rubber
friction wheel will result.
Should grease or oil come in contact with the disc drive plate
or friction wheel be sure to clean plate and wheel thoroughly
with a alcohol base solvent.
LUBRICATION - EVERY 10 HOURS
1. Auger Shaft- Using a hand grease gun, lubricate the
auger shaft zerk fittings (A) every ten (10) operating
hours. Each time a shear bolt is replaced, the auger shaft
MUST be greased (Figure 22). (See To Replace Auger
Shear Bolt in the Repair/Adjustment section).
2. For storage or when replacing shear bolts, remove shear
bolts and lubricate auger shaft zerks. Rotate augers sev-
eral times on the shaft and reinstall the shear bolts.
F_01160J 20
Loading ...
Loading ...
Loading ...