Loading ...
Loading ...
Loading ...
OPERATION
7. To stop forward motion, release traction drive clutch lever
(left hand - Figure 15).
8. To stop the auger, release auger drive clutch lever (right
hand - Figure 15).
9. To move the snow blower backwards, move speed select
lever into first or second reverse and engage traction
drive clutch lever (left hand). To stop, release traction
drive clutch lever.
WARNING: Never run engine indoors or in an
enclosed, poor ventilated area. Engine exhaust
contains CARBON MONOXIDE, an OR-
DERLESS and DEADLY GAS.
Keep hands, feet, hair and loose clothing away from
any moving parts on engine and snow blower.
Temperature of muffler and nearby areas can exceed
150 ° F (66 ° C). Avoid these areas.
DO NOT allow children or young teenagers to operate
or be near snow blower while it is operating.
WHEEL LOCK OUT PIN
1. The left hand wheel is secured to the axle with a klick pin.
This unit was shipped with this klick pin inthe locked posi-
tion. (Figure 16).
Locked
Position
Figure 16
2. For ease of maneuverability when lighter conditions pre-
vail, remove klick pin from wheel locked position and in-
sert into single wheel drive (unlocked) position
(Figure 17). Make sure that the klick pin is in the single
wheel drive position of the axle only and not through the
locked position.
Single Wheel
Drive Position
(Unlocked)
Figure 17
NOTE: Check tire pressure (20 pounds). See side of tire
for maximum inflation. Do not exceed listed maximum
pressure.
_lb WARNING: Do not attempt to remove any item
that may become lodged in auger without tak-
ing the following precautions:
• Release auger and drive clutch levers.
• Move throttle lever to STOP position.
• Remove the ignition key.
• Disconnect the spark plug wire.
• Do not put your hands in the auger or
discharge chute. Use a pry bar.
F_01160J 13
Loading ...
Loading ...
Loading ...