Loading ...
Loading ...
Loading ...
22
BEFORE USING THE MITER SAW
WARNING: To avoid mistakes that could cause serious, permanent injury, do not plug the tool
in until the following steps are completed:
● Completely assemble and adjust the saw, following the instructions (SEE ASSEMBLY AND
ADJUSTMENTS SECTIONS).
● Learn the use and function of the ON/OFF switch, upper and lower blade guards, hold-down
latch, bevel lock handle and cover plate screws.
● Review and understand all safety instructions and operating procedures in this Operator’s
Manual (SEE SAFETY & OPERATIONS SECTIONS).
● Review the MAINTENANCE and TROUBLESHOOTING for your miter saw.
● To avoid injury or possible death from electrical shock, make sure your ngers do not touch
the plug’s metal prongs when plugging or unplugging your miter saw (SEE ELECTRICAL
REQUIREMENTS AND SAFETY SECTIONS).
BEFORE EACH USE
Inspect your saw.
● Disconnect the miter saw. To avoid injury from accidental starting, unplug the saw before
making any adjustments, including setup and blade changes.
● Compare the direction of rotation arrow on the guard to the direction arrow on the blade. The
blade teeth should always point downward at the front of the saw.
● Tighten the arbor bolt.
● Tighten the cover plate screw.
● Check for damaged parts, including:
- Alignment of moving parts
- Damaged blade teeth
- Damaged electric cords
- Binding of moving parts
- Broken/cracked castings: base, table, motor, upper arm
● Function of arm return spring and lower guard: Push the cutting arm all the way down and
then let it rise until it stops. The lower guard should close fully. Follow the instructions in the
Troubleshooting for adjustment, if necessary.
● Keep all guards in place, in working order and properly adjusted. If any part of this miter saw
is missing, damaged or broken, or any electrical parts do not work, turn o the saw and unplug
it. Replace damaged, missing or defective parts before using the saw again.
● Maintain tools with care. Keep the miter saw clean for best and safest performance. Follow
instructions for lubricating. Do not apply lubricants to the blade while it is spinning.
● Remove all adjusting wrenches from the tool before turning it on.
USE ONLY THE RECOMMENDED ACCESSORIES
● Follow the instructions that come with the accessory. The use of improper accessories may
cause risk of injury to persons.
● Choose the correct 7-1/4 in. blade for the material and the type of cutting you plan to do.
● Make sure the blade is sharp, undamaged and properly aligned. With the saw unplugged,
push the cutting arm all the way down. Manually spin the blade and check for clearance. Tilt
the miter head to a 45° bevel and repeat the test.
● Make sure the blade and arbor collars are clean.
● Make sure all clamps and locks are tight and there is no excessive play in any parts.
OPERATING INSTRUCTIONS
Loading ...
Loading ...
Loading ...