Loading ...
Loading ...
Loading ...
17
● To remove, loosen and remove the four
screws (1) on the table insert (K) with a
Phillips screwdriver and remove the table
inserts.
● To install, reposition the table insert, install
the four screws and tighten.
WARNING: NEVER USE THE SAW
WITHOUT THE TABLE INSERT IN PLACE.
MOUNTING THE MITER SAW (FIG. 7, 8, 9)
To avoid injury from unexpected saw movement:
● Disconnect the power cord from the outlet
and lock the cutting head in the lower
position using the hold-down latch.
● To avoid back injury, lift the saw by using the
hand holds for transportation. Bend with your
knees, not your back.
● Never carry the miter saw by the power cord
or by the switch handle. Carrying the tool by
the power cord could cause damage to the
insulation or the wire connections resulting
in electric shock or re.
● To avoid injury from ying debris, do not
allow visitors to stand near the saw during
any cutting operations.
Mounting instructions:
● For stationary use, place the saw in the
desired location, directly on a workbench
where there is room for handling and proper
support of the workpiece. The base of the
saw has eight mounting holes (P - Fig. 7),
four 3/8 in. and four 9/32 in. holes. Select
the proper mounting holes based on the
size of bolts used. Bolt the base of the miter
saw (1) to the work surface (5), using the
recommended fastening method as shown
in Fig. 8.
NOTE: Mounting hardware is not included
with this tool. Bolts, nuts, washers and
screws must be purchased separately.
● For portable use, place the saw on a
3/4 in. thick piece of plywood. Bolt the base
of the miter saw securely to the plywood
using the 3/8 in. mounting holes (P - Fig. 7)
on the base. Use C-clamps to clamp this
mounting board to a stable work surface at
the worksite. (Fig. 9)
NOTE: If a miter saw stand is used, please
follow all instructions shown in that product’s
instructions for proper mounting.
WARNING
7
9
8
Stationary Use
1. Miter saw base
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Work surface
6. Flat washer
7. Lock washer
8. Hex/Lock nut
9. Jam nut
2
3
4
1
5
6
7
8
9
P
Portable Use
3/4 in. plywood
P
P
Loading ...
Loading ...
Loading ...