Loading ...
Loading ...
Loading ...
16
ADJUSTMENT INSTRUCTIONS
5
UNLOCKING AND LOCKING THE CUTTING
HEAD (FIG. 5)
Unlocking the cutting head:
● To raise the cutting head from its storage/
transport position: push down slightly on the
switch handle (F).
● Pull out the hold-down latch (T).
● Allow the cutting head to rise to the
up position.
Locking the cutting head:
When transporting or storing the miter saw, the
cutting head should always be locked in the
down position.
● Push the cutting head down to its lowest
position.
● Push the hold-down latch (T) into the
locking hole.
CAUTION: To avoid injury and damage to
the saw, transport and store the miter saw
with the cutting head locked in the down
position. Never use the hold-down latch to
hold the cutting head in a down position for
cutting operations.
IMPORTANT: To avoid damage, never carry the
miter saw by the switch handle, the cutting arm
or the miter table handle. ALWAYS use the hand
holds for transportation.
REMOVING AND INSTALLING THE TABLE
INSERT (FIG. 6)
NOTE: The miter saw comes with the table
insert already installed. These instructions are
for replacing or adjusting the insert.
To avoid injury:
● Always unplug the saw to avoid accidental
starting. Remove all small pieces of material
from the table cavity before performing any
cuts. The table insert may be removed for
this purpose, but always reattach the table
insert prior to performing a cutting operation.
● Do not start the compound miter saw without
checking for interference between the blade
and table insert. Damage could result to the
blade, table insert or turntable if blade strike
occurs during the cutting operation.
6
WARNING
1
F
T
K
Loading ...
Loading ...
Loading ...