Husqvarna K 760 CUT-N-BREAK Operator's Manual

Loading ...

MAINTENANCE

24 – English

Fitting the starter

• To fit the starter, first pull out the starter cord and place

the starter in position against the crankcase. Then

slowly release the starter cord so that the pulley

engages with the pawls.

• Tighten the screws.

Fuel system

General

• Check that the fuel cap and its seal are not damaged.

• Check the fuel hose. Replace when damaged.

Fuel ﬁlter

• The fuel filter sits inside the fuel tank.

• The fuel tank must be protected from contamination

when filling. This reduces the r

isk of operating

disturbances caused by blockage of the fuel filter

located inside the tank.

• The filter cannot be cleaned but must be replaced with

a ne

w filter when it is clogged. The ﬁlter should be

changed at least once per year.

Air ﬁlter

The air filter only needs to be checked if the engine drops

in power.

• Loosen the screws. Remove the air filter cover.

• Check the air filter and replace if necessary.

Replacing the air ﬁlter

• Loosen the screws. Remove the cover.

• Replace the air filter.

Drive gear, clutch

• Check the clutch centre, drive gear and clutch spring

for wear.

Water tap

• Check and clean the restrictor if necessary.

NOTICE! The air filter must not be cleaned or blown

clean with compressed air. This will damage the filter.

Loading ...

Husqvarna K 760 CUT-N-BREAK K 760 Cut-n-Break Power Cutter