Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 83
Adjusting Centerline
Refer to the following steps to manually adjust the
ce
nterline:
1. Press the Adjust Centerline button located in
the bottom right corner of the Cargo Camera
display.
2. Use the arrows on the bottom left corner of the
C
argo Camera display to adjust the centerline
horizontally or vertically.
3. Once the desired position is achieved, press
t
he Accept button to set the centerline to the
newly specified position.
Deactivation
The Dynamic Centerline feature will automatically
b
e deactivated whenever the Cargo Camera
display is deactivated. It can also be manually
deactivated through the Uconnect Settings
Ú page 229.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Cargo Camera image will be
di
splayed continuously until the touchscreen
X button to disable display of the Cargo Camera
image is pressed.
The touchscreen X button to disable the display
of the camera image is made available ONLY
when the vehicle is not in reverse.
If snow, ice, mud, or any foreign substance
builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do not
cover the lens.
Turning Cargo Camera On Or Off —
With Uconnect 4C/4C NAV
1. Press the Controls button located on the
bottom of the Uconnect display.
2. Press the Cargo Camera button to turn the
Cargo Camera system on.
NOTE:
Once initiated by the Cargo Camera button, the
Ca
rgo Camera image will be displayed until the
vehicle speed remains below 8
mph (13 km/h)
and the 10 second timer runs out. The image may
be deactivated by pressing the touchscreen
X button, placing the ignition in the OFF position,
pl
acing the gear selector in PARK, or pressing the
image defeat X button. On deactivation, the
previous selected screen will appear.
BED RAIL TIE-DOWN SYSTEM —
I
F EQUIPPED
NOTE:
This feature is only available for vehicles equipped
wi
th a RamBox.
There are two adjustable cleats on each side of the
bed that can be used to assist in securing cargo.
Adjustable Cleats
CAUTION!
The maximum load per cleat should not exceed
250 lb (113 kg) and the angle of the load on
each cleat should not exceed 45 degrees above
horizontal, or damage to the cleat or cleat rail
may occur.
2
Loading ...
Loading ...
Loading ...