Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 125
If the vehicle is not in PARK and the driver turns off
the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with a rotary shifter and an
8-Speed transmission
Vehicle is not in PARK
Vehicle speed is 1.2 mph (1.9 km/h) or less
Ignition switched from ON/RUN to ACC
NOTE:
For Keyless Enter ‘n Go™ equipped vehicles, the
en
gine will turn off and the ignition switch will
change to ACC mode. After 30
minutes the ignition
switches to OFF automatically, unless the driver
turns the ignition switch off.
If the vehicle is not in PARK and the driver exits the
ve
hicle with the engine running, the vehicle may
AutoPark.
AutoPark will engage when all of these conditions
ar
e met:
Vehicle is equipped with a rotary shifter and an
8-Speed transmission
Vehicle is not in PARK
Vehicle speed is 1.2 mph (1.9 km/h) or less
Driver’s seat belt is unbuckled
Driver’s door is ajar
Brake pedal is not pressed
The message “
Au
toPark Engaged Shift to P then
Shift to Gear” will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be
di
splayed in the instrument cluster, causing the
“
AutoPark Engaged Shift to P then Shift to Gear” to
not be seen. In these cases, the shifter must be
returned to “P” to select desired gear.
If the driver shifts into PARK while moving, the
ve
hicle may AutoPark.
AutoPark will engage
ONLY when vehicle speed is
1.2
mph (1.9 km/h) or less.
The message “
Vehicle Speed is Too High to Shift
to P”
will be displayed in the instrument cluster if
v
ehicle speed is above 1.2 mph (1.9 km/h).
4WD Low — If Equipped
AutoPark will be disabled when operating the
v
e
hicle in 4WD Low.
The message “
AutoPark Disabled” will be
displayed in the instrument cluster.
Additional customer warnings will be given when
al
l of these conditions are met:
Vehicle is not in PARK
Driver’s door is ajar
Vehicle is in 4WD Low range
The message “Au
toPark Not Engaged” will be
displayed in the instrument cluster. A warning
chime will continue until you shift the vehicle into
PARK or the driver’s door is closed.
ALWAYS DO A VISUAL CHECK that your vehicle is in
PARK by looking for the “P” in the instrument
cluster display and near the shifter. As an added
precaution, always apply the parking brake when
exiting the vehicle.
If Engine Fails To Start
If the engine fails to start after you have followed
the “Normal Starting” procedure, it may be
flooded. Push the accelerator pedal all the way to
the floor and hold it there while the engine is
cranking. This should clear any excess fuel in case
the engine is flooded.
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h), the
transmission will default to NEUTRAL until the
vehicle speed drops below 1.2
mph (1.9 km/h).
A vehicle left in the NEUTRAL position can roll. As
an
added precaution, always apply the parking
brake when exiting the vehicle.
4
Loading ...
Loading ...
Loading ...