Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 341
REINSTALLING THE JACK AND TOOLS
1. Tighten the jack all the way down by turning
the jack turn-screw counterclockwise until the
jack is snug.
2. Position the jack and tools into bracket
a
ssembly. Make sure the lug wrench is under
the jack near the jack turn-screw. Snap tools
into bracket assembly clips. Install the jack
into bracket assembly and turn the jack
turn-screw clockwise until jack is snug into
bracket assembly.
Jack And Tools Bracket Assembly
3. Place the jack and tool bracket assembly in the
storage position holding the jack by the jack
turn-screw, slip the jack and tools under the
seat so that the bottom slot engages into the
fastener on the floor.
Jack Hold Down Fastener
NOTE:
Ensure that the jack and tool bracket assembly
sl
ides into the front hold down location.
4. Turn the wing bolt clockwise to secure to the
floor pan. Reinstall the plastic cover.
Wing Bolt/Jack And Tools
HUB CAPS/WHEEL COVERS — IF EQUIPPED
The hub caps must be removed before raising the
vehicle off the ground.
For 2500/3500 Single Rear Wheel (SRW) models,
use the flat end of the lug wrench to hook and pull
off the hub cap. Find the opening in the hub cap,
insert the lug wrench, and pull off the cap. If you
need to pry against the wheel, protect the wheel
surface.
Lug Wrench Insertion Location — Hub Cap
CAUTION!
Use extreme caution when removing the front
and rear wheel covers. Damage can occur to the
center cap and/or the wheel if screwdriver type
tools are used. A pulling motion, not a pry off
motion, is recommended to remove the caps.
7
Loading ...
Loading ...
Loading ...